RV axle flips 101
Gear, Tech & Tips
September 28, 2010

RV axle flips 101

For those RV enthusiasts that like to take their RV into the backcountry and have a lift kit on the tow vehicle or other clearance concerns—an axle flip will be beneficial.

For those RV enthusiasts that like to take their RV into the backcountry and have a lift kit on the tow vehicle or other clearance concerns—an axle flip will be beneficial and cost-saving.

An axle flip can help prevent possible holding tank, gate valve, stabilizer jack damage or axle component wear from increased weight on the rear axle.

Basically, an axle flip involves removing the axles from the normally mounted position above the springs known as overslung to under the springs known as underslung, which will add clearances of about 4 to 6 inches below the previous frame height from the ground.

Firstly, I would like to discuss this task for a do-it-yourself project without the proper knowledge of electric brake characteristics, proper camber of the axle or limited welding skills.

At our shop we have seen trailers with the drop spindle type axle actually ‘’flipped’’ over upside down to increase ground clearance.

This axle flip attempt will affect braking, tire wear and could be a serious safety concern. The electric brake system has an actuator arm where the brake magnet is mounted and needs to be positioned in front of the axle spindle to function properly.

The axle is designed for expected deflection under added loads in relation to the road surface which is referred to as caster. Having the caster angle upside down will cause premature tire wear.

Another issue for do-it-yourself folks is using a torch to cut the existing axle saddles or spring perches off with an acetylene torch to be used for the new axle position. If the axle tube is burnt through the integrity of the axle will be compromised.

Lastly, you should never use the existing U-bolts to complete an axle flip. It is advisable to put new U-bolts and torque to the manufactures specified torque settings.

Your local RV service centre will usually have all the equipment available to complete the job and the costs for labour and parts can be quite reasonable. This would also be an excellent time to check the rest of the suspension such as bearings, shoe linings and hubs.

Some considerations that may be overlooked after an axle flip are: adjustments to the pin box height for proper box clearances, changing the step size to a two- or three-step assembly, modifying the shock mounts at the tie plates and frame to accommodate the new shock angles and adjusting the ball mount height.

After an axle flip has been completed it is advisable to check the U-bolts, shackle and equalizer bolts for proper torque settings after the first 90 kilometres or 50 miles.

 

More stories

Spring prep tips for your RV
Gear, Tech & Tips

Spring prep tips for your RV

Reg DeYoung, an RV technician with Runners RV in Cranbrook, B.C., shares tips on how to inspect your RV when you take it out of storage.

Reg DeYoung
February 19, 2026

Preparing your RV for winter
Gear, Tech & Tips

Preparing your RV for winter

It takes careful planning and cunning execution to prevent Old Man Winter from sneaking in to freeze your pipes.

Timothy Fowler
September 1, 2024

10 Common mistakes new RVers make
Gear, Tech & Tips

10 Common mistakes new RVers make

If your RV experience involves some trial and error, you're not alone!

Carol Ann Quibell
November 9, 2023

Advertisement
Billboard
970 × 250 · 300 × 250 on phones