Reg replies to readers’ questions
Gear, Tech & Tips
April 17, 2013

Reg replies to readers’ questions

RV technician Reg DeYoung, who works at Runners RV in Cranbrook, B.C., answers your RV questions.

Question

Thanks for your checklist article. I'm wondering if you can tell me what a dry lubricant is for lubricating the slide-out mechanism? Also, do you think it's a good idea to use exterior supports under the slide-out?

Thanks for your reply,
Jack

Answer

Hello Jack:

Glad you enjoyed the latest Tech Talk article. To answer your question, dry lubricants like those used for slide-outs are materials that, despite being in a solid form, are able to reduce friction between moving parts without the need of a liquid medium. The lubricant will produce a dry, waxy, protective film when sprayed. There are some great products available at your local RV parts store from suppliers like Protect-All, Thetford and Camco. When spraying these products, ensure that you have a piece of cardboard or wood above the slide rack to keep the lubricant away from the slide-out underside.

In regards to slide-out supports, they are of benefit for long-erm parking. You should use the frame-mount stabilizers as well. Barker Manufacturing, Stromberg-Carlson and Ultra Fab manufacture these units.

Thanks for your question,
Reg

Question

We have a newer trailer set up on a lot at a lake in Alberta. We are hooked up to the trailer park’s water system. For the past two seasons we are getting a large amount of air in the hot water lines, yet our neighbours do not have this problem. Any ideas how all this air is getting into the system? 

Thanks,
Stan

Answer:

Hello Stan:

I would like to recommend a procedure to hopefully eliminate your water system problem. Shut off the city water and only after the hot water heater has cooled down, open the pressure relief valve (brass valve with lever) on the outside area of the water heater until water stops flowing from the tank. Snap the valve shut and turn the water back on. Next, go into the RV and open the hot water faucet closest to the hot water heater and let it flow until a clear, steady stream is obtained. Operate the water heater up to temperature and check water flow. You’re welcome to let me know if the procedure is successful or not.

Thanks for your question,
Reg                                                                                                                                                       

Question

When towing an SUV behind a motorhome with the Blue Ox tow hitch, does anything have to be done for braking, or just let the tow vehicle free-wheel?

Answer

In British Columbia the law states the following:

Motorhomes (only) may tow a motor vehicle via a tow bar without brakes hooked up on the towed vehicle, when the towed motor vehicle laden weight (weight of the towed vehicle and its load) is less than 2,000 kg (4,409 lbs) and less than 40 per cent of the gross vehicle weight (GVWR) rating of the motorhome towing it.          

Motor vehicles with laden weight of 2,000 kg (4,409 lbs) and over must have brakes and a breakaway device hooked up.

Thanks for your question,
Reg

Do you have a question for Reg? Contact him by email.

More stories

Spring prep tips for your RV
Gear, Tech & Tips

Spring prep tips for your RV

Reg DeYoung, an RV technician with Runners RV in Cranbrook, B.C., shares tips on how to inspect your RV when you take it out of storage.

Reg DeYoung
February 19, 2026

Preparing your RV for winter
Gear, Tech & Tips

Preparing your RV for winter

It takes careful planning and cunning execution to prevent Old Man Winter from sneaking in to freeze your pipes.

Timothy Fowler
September 1, 2024

10 Common mistakes new RVers make
Gear, Tech & Tips

10 Common mistakes new RVers make

If your RV experience involves some trial and error, you're not alone!

Carol Ann Quibell
November 9, 2023

Advertisement
Billboard
970 × 250 · 300 × 250 on phones